Download Article

Download Article

Mod soft convertible motorcar tops oftentimes accept glass windows glued to the fabric, vinyl or other soft material with a melted plastic strip instead of a clear vinyl window sewn to information technology. If and when the glass comes unstuck -- sometimes due to the canvas shrinking from fail or otherwise -- information technology tin be very difficult to reattach. Double-sided cream record such equally 3M VHB tape (what one writer used, others could be OK too) tin reattach them, but should exist practical in a specific fashion to avert abiding strain that will break its bail.

Steps

  1. ane

    Reattach the soft superlative material ("canvass") to the drinking glass when just part of the sail has discrete so that the glass does not have to be re-centered within the pigsty in the canvas. If it does have to be re-centered one might do that by measuring distances with the defrosting filigree as a guide and, in any case, holding the drinking glass temporarily in place with gaffer's or other sticky tape.

  2. ii

    Open the top slightly and so that it is not taut. Prop something such as a small empty box between the front edge of the top and the upper edge of the windshield frame and so that the superlative stays open slightly.

    Advert

  3. 3

    Find the seal that was attached but has become unattached, such as the lower border of the exterior layer of canvas. [ane] If dirt has accumulated in the pocket that has been exposed to the weather you may wish to vacuum out any large particles.

  4. 4

    If only a very small function has separated leave information technology alone. If a large part is mostly separated you may wish to separate it entirely to re-seal information technology as one continuous piece.[2]

  5. five

    Clean the mating surfaces with rubbing alcohol.

  6. vi

    Close the roof completely to see where the canvas falls on the glass when pulled gently apartment as far in on the glass as it will go, merely not pulled difficult. At to the lowest degree in the example of cotton fiber canvas, this volition probably be not as far up onto the glass equally originally (or as on a still-fastened within layer) because it will have shrunk since new.

  7. vii

    Re-open the roof slightly and re-prop it.

  8. eight

    Apply a strip of double-sided foam tape such as 3M VHB ("very high bond")--foam and so that it will conform to whatsoever irregularities, preferably black and so ultraviolet rays will not promptly destroy its exposed edge--to the drinking glass with the border coming upwards to the point yous determined previously. [3]

  9. nine

    Bring the eye of the area being attached (such as the middle, left-versus-right-wise of the bottom exterior canvas) up to the edge of the tape. Information technology should have just a little slack, since information technology needs to be pulled basically smooth but not taut when the acme is closed. Just a little slack when the top is closed is much better than tension, which will unstick the tape.

  10. 10

    Stick the sail to the record, working outward. The reason to work outward from a key indicate is so that any "backlog" material does not build up at one side.[4]

  11. xi

    Rub down the canvas over the tape firmly and employ some oestrus--not a smashing painfully hot amount--with a accident dryer for a thorough bond.

    • The convertible peak should exist fixed.

    Advertisement

Add New Question

  • Question

    How much volition it price to replace the top with the original window?

    Community Answer

    I accept a 2007 Mustang convertible. The window is separating from the fabric top. I went to two convertible top/upholstery shops, and both told me the window is heat sealed and the entire top needed to be replaced, and both gave me a price of $1,900.

  • Question

    I accept in my garage a Corvette convertible with a canvas top in cracking condition. The seal effectually the drinking glass rear window has popped, volition this process work?

    Community Answer

    I used 3M window weld on our 2004 Volvo C70 summit and it worked great! Make certain you get as much of the old adhesive off as possible. Put the 3M primer on first and let it dry for almost 10 minutes. Put a dewdrop (most 3/16) of window weld on it. Clench information technology in place. I used some pigment stirrer sticks & C clamps. Allow it sit for nigh 24 hours. Do non practice this if temperature is below xl degrees F.

  • Question

    Where tin can I become 3M VHB cream tape?

    Community Answer

    Amazon has it in a variety of lengths and widths.

  • Question

    Can Gorilla gum be used to adhere glass to a convertible canvass top?

    Community Answer

    No. I tried it and the heat from sitting in the lord's day made information technology crack and come apart.

  • Question

    How much volition it cost to supersede a rear window on a convertible Sebring?

    Community Answer

    The shops will tell you a new top is needed. Fortunately, the Sebring window lays on height of the canvas flap rather than hanging from it. People swear past Rhinoceros mucilage for about 20 bucks. I'thou planning to remove the window, clean the entire lip that the window edge contacts, put a bead of rhino on information technology and lay the window back in. Removing it completely volition allow me to position it evenly in the hole since the height material has most likely shrunk over the years but if yours is only pulling apart in a section yous can open the top part way and glue the lip while tension is off.

  • Question

    Should I gum the inside and the outside of the window?

    Brett Gilbert

    Brett Gilbert

    Tiptop Answerer

    Yeah, if the canvas is loose on the within part of the window, glue it every bit well.

  • Question

    Where can I find instructions that are more specific to the type of car I accept?

    Brett Gilbert

    Brett Gilbert

    Top Answerer

    You could contact the manufacturer or a mechanic to see what they recommend. Unremarkably, though, they will tell you to replace the entire hood. The glue or record techniques work well for just well-nigh any machine.

Ask a Question

200 characters left

Include your email address to get a bulletin when this question is answered.

Submit

Advertisement

  • It may be better to get the superlative fixed in a way for whose possible failure someone else such as a dealer will take responsibleness. Simply this is a slap-up alternative to replacing the peak.

Advertising

Things You'll Demand

  • 3M VHB foam tape, black

References

Most This Commodity

Thank you to all authors for creating a page that has been read 200,550 times.

Reader Success Stories

  • Anthony Budd

    Anthony Budd

    Jul 21, 2022

    "You lot told me how to set a convertible rear superlative when specialty shops said replace the top. Information technology's a 2002 erstwhile Sebring,..." more than

Did this article help you lot?